Gen 3 Starlink TRIO Pole Mount
Keep your Starlink Gen 3 Standard dish secure with this extra sturdy pole mount.
The TRIO Gen 3 Pole Mount is a convenient option for those wanting to mount their Gen 3 Starlink in a secure and convenient way at home, or on their boat or RV. Simply press the tabs on the Starlink kickstand and slide it out, and slide in the TRIO Pole Mount until it clicks in firmly, place it over a 2” Flag Pole Buddy pole (OR Harbor Freight: 1.65”, 1.5”, or 1” poles with correct insert), then simply tighten the M6 screws to cinch the mount on the pole and you’re all set!
** If wanting multiple inserts, please indicate so via drop down option and specify which inserts in the “Additional Information” box during checkout ($10 extra per additional insert)
** We recommend to use the through bolt hole to drill out a hole in your pole and through bolt with 75mm M6 stainless hardware (available as add-on in drop down option).
Featuring stainless steel M6 screw and nylon lock nut hardware and manufactured from waterproof and UV thermoplastic that will not warp, the TRIO Gen 3 Pole Mount is built to last. It tilts the dish at an 8 degree angle to allow water run off and aerodynamic positioning. The pole mount also has a space for the Starlink cable to pass though.
** NOTE: Due to the 8 degree angle (instead of 20 degrees that the starlink kickstand gives) the app will show a notification that the dish needs to be aligned. This does not affect performance in any way in our testing.
If you already have a previous pole mount for Gen 1 or 2 Kits, use this pole mount (with or without insert) to fit on the same pole.
Made in BC, Canada.
For additional info, see below.
-
Manufactured from waterproof and UV thermoplastic that will not warp.
Can be used with 2”, 1.65” (harbor freight or similar), 1.5”, and 1” poles (please select insert size needed depending on your pole’s outer dimension). Rubber grip tape can also be used to thicken slightly smaller poles to fit above dimensions. If you think we’re missing an insert for a common dimension pole, send us an email and we’ll see what we can do!
-
Overall Dimensions: 4.1"H x 7.25”W x 5.7” D
(Total height of pole mount section is 2.75”)Inside Diameter: 2” (1.65”, 1.5”, and 1” ID inserts also available)
Color options: Black or White -
⚠ Given the varying conditions of poles that this can be mounted to and rooftop scenarios/environments that this may be mounted in, it is ultimately up to the end user to make sure the antenna mount is sufficiently secured and the install is done safely. By purchasing and using this product, you agree to waive any claims that you may have against TRIO Flatmount, www.trioflatmount.com, and included entities, from any and all liability for any loss, damage, expense or injury, including death, that may suffer as a result of the use of the product, due to any cause whatsoever.
-
Please visit our FAQ page for our return policy and our warranty.
