Essential Adhesive Kit – Gen 3 Standard Speedmount

The discs bond down for good. The dish lifts off whenever you want.

The TRIO Speedmount Adhesive Kit is a low-profile, secure solution for mounting your Gen 3 Starlink dish onto your van, RV, truck, trailer, camper, boat, or overland vehicle. With VHB Adhesive-Backed Magnet Mounting Discs, our Rubber-Coated Magnet Set, and the Gen 3 12V Power Supply included, this kit gives you everything you need to mount and power your Starlink without drilling.

Manufactured using industrial-grade injection molding, the Speedmount protects the edges of the Gen 3 dish and remains extremely low profile at only 1.85” in height. To assemble, simply slide the four pieces into place around the Starlink Gen 3 Standard dish and tighten the stainless steel screws into the stainless steel nylon locknuts.

Here is how this kit works. The mounting discs bond to your roof with 3M industrial-strength VHB adhesive. That bond is permanent, so mark your placement and get it right the first time. The discs turn the surface into a magnetic landing zone. The Rubber-Coated Magnets then sit on top of the discs and hold the mount down. The magnets are the part that comes off. Lift the dish for storage, service, a low garage, or winter layup, then drop it back in seconds with no tools and no adhesive to replace.

On bare or painted steel you can skip the discs and set the magnets straight onto the surface. Use the discs for fiberglass, aluminum, painted metal, and composite roofs where a magnet has nothing to grab. This works on RV roofs, vans, trailers, box trucks, marine cabins, and sailboats. The kickstand or pole mount still work and can be used in conjunction with the Speedmount.

Strength: This mount has been designed to be used at high speeds when properly installed and fully cured. It is ultimately up to the end user to make sure the antenna mount is secured appropriately.

TRIO-Grade Features:

• Safety tested at highway speeds
• No drill
• Snowmelt protection
• Heat-transfer optimization
• Signal performance prioritization

What’s Inside the Kit

Gen 3 Standard Speedmount

A durable, low-profile mounting frame for the Gen 3 Standard Starlink dish.

Industrial-grade ASA injection molding
Only 1.85” tall
Protects and stabilizes the edges of the dish
Simple 4-piece assembly with stainless steel hardware
Compatible with kickstand and pole mount setups

VHB Adhesive-Backed Magnet Mounting Discs

Turn a non-magnetic roof into a magnetic mounting point.

Weatherproof steel discs backed with 3M industrial-strength VHB adhesive
Safe for fiberglass, aluminum, painted metal, and composite roofs
Permanent bond once cured, so confirm your placement before pressing down
Weather-resistant and vibration-resistant
Creates a stable, low-profile magnetic base for the Speedmount

Rubber-Coated Magnet Set

Strong holding force with a paint-safe grip.

Holds securely at highway speeds when properly placed
Sits on top of the mounting discs, or straight onto a bare or painted steel roof
Rubber-coated to protect your vehicle’s finish
Drops on and lifts off in seconds, no tools required
Ideal for RVs, vans, trucks, trailers, boats, and marine cabins

Gen 3 12V Power Supply

A direct 12-volt power source for Starlink Gen 3.

Bare wire leads for a hardwired connection to your 12V or 24V system
Efficient 12V connection without needing an inverter
Perfect for travel days, remote work, or off-grid use