Gen 2 Performance (Maritime Flat High Performance) Speedmount

Yes. The Performance Gen 2 Speedmount is engineered and tested for high-wind and rough-condition use. As long as you've installed it on a clean surface and the mount doesn't budge when you give it a firm push, you're good to go. If you've chosen suction cups as your attachment method, give the suction a quick check before any drive.

Attaching the Performance Gen 2 Speedmount on an aluminum body, you've got a few options depending on how permanent you want the install. Aluminum is non-ferrous, so:

For a permanent install, go with our VHB Adhesive Landing Pads. They bond directly to the aluminum.

For semi-permanent, pair our Rubber-Coated Magnets with our VHB Metal Discs. The disc bonds to the aluminum and the magnet locks onto the disc, giving you a strong hold you can still remove later.

Heavy-Duty Suction Cups are also an option if you want a fully removable setup.

Attaching the Performance Gen 2 Speedmount on a fiberglass roof, you've got a few options since fiberglass is also non-ferrous, same setup as aluminum:

For a permanent install, use our VHB Adhesive Landing Pads. They bond directly to the fiberglass.

For semi-permanent, pair our Rubber-Coated Magnets with our VHB Metal Discs. The disc bonds to the fiberglass, and the magnet locks onto the disc.

Heavy-Duty Suction Cups also work if you want a fully removable setup.

Yes. Each magnet has 60 lbs of holding force, so all 4 magnets together hold up to 240 lbs. To remove them, slide them side to side with a bit of force rather than pulling straight up.

Go with our Swivel Leg Mount Adapters. Each leg gets independent movement so the mount can conform to a curved surface and sit flush without rocking.

Attaching the Performance Gen 2 Speedmount on a Ford roof, most Ford trucks newer than 2016 have an aluminum roof, which is non-ferrous, so you've got a few options depending on how permanent you want the install:

For a permanent install, go with our VHB Adhesive Landing Pads. They bond directly to the aluminum.

For semi-permanent, pair our Rubber-Coated Magnets with our VHB Metal Discs. The disc bonds to the aluminum and the magnet locks onto the disc, giving you a strong hold you can still remove later.

Heavy-Duty Suction Cups are also an option if you want a fully removable setup.

Yes, the Performance Gen 2 Speedmount will hold if you choose one of the above.

We don't recommend it. The mount is built to handle weather and road grime, but automatic car washes put extra stress on the dish and attachment points with high-pressure jets and rotating brushes. Remove the dish (and the Performance Gen 2 Speedmount if you're going through a touchless or brush wash) before you head in, then reinstall once you're out.

Depends on your setup. We make a dedicated 12V power option for the Performance Gen 2 dish.

If you're keeping the Starlink router, use our HP 12V Conversion. It powers the Performance Gen 2 dish directly from your 12V or 24V system, eliminating the need for an inverter and reducing wasted power. It's designed specifically for the High Performance / Performance Gen 2 Starlink system and works great for mobile and off-grid setups.

No, the Performance Gen 2 Speedmount doesn't come with attachments. You pick the attachment method separately so it fits your vehicle and use case. Options include Rubber-Coated Magnets, VHB Metal Discs, VHB Adhesive Landing Pads, Heavy-Duty Suction Cups, and Swivel Leg Mount Adapters.

Yes. Every TRIO mount purchased directly from trioflatmount.com is covered by our TRIO Lifetime Guarantee. If your mount ever fails, send photos or video of the issue along with your order number to contact@trioflatmount.com and we'll take care of it.