Gen 3 12V Conversion Box (For Aftermarket Router)

Our Gen 3 12V Conversion box contains our POE injector and 12-56V converter inside to allow plug and play use with an aftermarket router like Peplink (not included). This eliminates the need to use the Gen 3 router in addition to your existing aftermarket router which results in more power savings (~15w draw from the Gen 3 router)!

Simply connect the included SAE 5’ cable to a 12V power source (DC input range is 10-30V) and plug in your Gen 3 Starlink ethernet cable into the port labeled DISH.

** Works with snowmelt! Our POE has been load tested to over 200W which is more than enough for Gen 3 snowmelt.

Power Consumption tested over 1 hour with constant upload/download internet: ~40 Wh (~3A at 13.8V) - not including aftermarket router power consumption which will vary depending on your specific model.

Please select the appropriate connector for your application from the drop down: bare wire leads or ring terminals.

** We recommend using 15A fuse on your 12V fuse block or adding an in-line fuse on the positive lead.

See installation instructions here : Installation instractions

⚠ Using Starlink™ in motion may violate your Terms of Service depending on your service location. Consult your Terms of Service to determine if this applies to you.

⚠ Given the varying conditions of surfaces this can be mounted to, it is ultimately up to the end user to make sure the antenna mount is sufficiently secured. By purchasing and using this product, you agree to waive any claims that you may have against TRIO Flatmount, www.trioflatmount.com, and included entities, from any and all liability for any loss, damage, expense or injury, including death, that may suffer as a result of the use of the product, due to any cause whatsoever.

See our warranty here: Warranty