Gen 3 Flatmount

To install, simply: 

1. Apply your attachment of choice (e.g., Magnet, Suction Cup, VHB Landing Pad, etc.)

2. Snap the Flatmount onto the Starlink 

3. Attach to your roof or other surface

That’s it! (For additional info, check out our instruction booklet.)

Planning to mount your Starlink onto a fully exposed location traveling at highway speeds or faster? Check out the TRIO Gen 3 Speedmount.

Dimensions: 12" x 10.5" x 1 7/8"

Less than 2.125 in/5.4 cm install height with TRIO Rubber Coated Magnets

This mount has been designed and tested for driving conditions under 60mph with average to below average turbulence.

Trucks & Cars
Low-profile and form-fitting, it won't snag on branches or clearance bars. Works with magnetic, suction, VHB, or through-bolt attachment — whatever your rig needs.

RVs
A dedicated Starlink RV Flatmount. Works on fiberglass and aluminum rooftops. VHB Landing Pads provide a permanent solution, with professional-grade Magnets for removable and tool-free use.

Vans & Overlanders
For van conversions and overland rigs. The TRIO Flatmount sits tight to the roof and keeps the dish protected during travel, and comes off quickly.

Boats
If your water-rig is utilizing a Standard Starlink, TRIO Flatmount installs in minutes using Heavy-Duty Suction Cups. No drilling, no damage.

If your vehicle's roof has raised ridges or contours, any attachment may not achieve full contact with the roof surface, and full contact is required for a secure hold. Without it, the mount can detach at highway speeds. If your roof has ridges, we recommend:

• Ensuring all attachment points are flush and fully in contact with the roof before driving
• Testing the mount at low speeds before highway use

Not sure if your setup is compatible? Reach out before purchasing at contact@trioflatmount.com and we'll help you find the right solution.