Essential Adhesive Kit - Gen 3 Standard Flatmount
Compatible with Starlink Standard 4
Free shipping on orders over $175.
Description
The TRIO Flatmount Adhesive Kit is a low-profile mounting solution for those wanting to mount their Gen 3 Standard Starlink dish securely and permanently on their RV, van, boat, trailer, truck, or marine surface without drilling. Simply press the tabs on the Starlink kickstand, slide it out, click the dish into the TRIO Flatmount, install the VHB landing pads on your surface, allow proper cure time, and your dish is ready to use.
The Gen 3 TRIO Flatmount is intended for permanent installation on Vans, RVs, Box Trucks, Campers, Boats, Sailboats, Trailers, and more. With the included VHB Adhesive Landing Pad Set and Gen 3 12V Power Supply, this kit provides a clean, reliable, and drill-free adhesive mounting and power solution for travel days, remote work, stationary setups, or long-term off-grid use.
NOTE: If you have a curved roof, the mount has slight flex, but you may need our Swivel Leg Mount Adapters for maximum surface area contact when using VHB Adhesive Landing Pads, magnets, or suction cups. Add to your order if required.
Strength: This mount has been designed to be used in normal driving conditions and wind turbulence when installed correctly. We recommend installing behind another item (such as an AC unit or storage box) for wind dampening and to protect the dish. It is up to the end user to ensure the adhesive installation is secured appropriately. For fully exposed locations or higher speeds, we recommend our Gen 3 Standard Speedmount.
TRIO-Grade Features:
- Safety tested at highway speeds
- No drill
- Snowmelt protection
- Heat-transfer optimization
- Signal performance prioritization
What’s Inside the Kit
Gen 3 Standard Flatmount
A low-profile mounting base designed specifically for the Starlink Gen 3 Standard dish.
Clicks directly into the Starlink dish without tools
Industrial-grade ASA injection molding
Slim design for reduced wind exposure
Suitable for permanent or temporary installations on vehicles and marine setups
VHB Adhesive Landing Pad Set
A permanent, drill-free adhesive mounting solution for flat or slightly curved surfaces.
Uses 3M VHB adhesive for strong, long-term bonding
Safe for fiberglass, aluminum, painted metal, and composite roofs
Weather-resistant and vibration-resistant
Creates a stable, low-profile mounting base for the Flatmount
Ideal for vans, RVs, trucks, trailers, and marine use
Gen 3 12V Power Supply
A direct 12-volt power source for Starlink Gen 3.
Bare wire leads for a hardwired connection to your 12V or 24V system
More efficient than running an inverter
Perfect for travel days, off-grid work, or mobile operations
TRIO Lifetime Guarantee
Non-Flat or Ridged Roof? Read This Before Mounting
