Gen 3 Standard Speedmount
Need a a Power Cable?
The TRIO Speedmount is a low profile mounting solution for those wanting to mount their Gen 3 Starlink in a secure and convenient way on their van, RV, side by side, UTV, or race truck! This mount provides protection to the edges of the dish and is extremely low profile at only 1.85” in height (1.9” with magnets). Simply slide the 4 pieces into place around the Starlink gen 3 standard dish and tighten the 4 SS screws into the SS nylon locknuts.
This allows you to flatmount your gen 3 dish permanently or temporarily on any vehicle: Vans, RVs, Box Trucks, Campers, Boats, Sailboats, etc. There are multiple mounting options as noted in the drop down menu (through bolt in the corners, rubber coated magnets, or suction cups. VHB powder coated steel discs available for non magnetic surfaces).
** The kickstand or pole mount still work and can be used in conjunction with the speedmount.
** Combine it with our All In One 12V attachment!
** Strength: This mount has been designed to be used (and has been tested) at high speeds. It is ultimately up to the end user to make sure the antenna mount is secured appropriately.
For additional info and mounting instructions, see below.
Customer Reviews
Holds the Starlink panel securely to the top of my Vans rack. That is it's only job.
I had purchased this mount with the suction cup attachments. One of the suction cups lost its key component that enables it to hold suction. I contacted Trio Flatmount and they quickly remedied the issue, sending a new singular suction cup to replace! Fantastic product - fantastic service!
I just got my Trio Speedmount and put it on my 2022 Toyota Tundra. It works perfect. The magnets are super strong and placed perfect. The dish and mount sit low so there is no wind drag and noise. If your going to get a mount for the Starlink Gen 3, this is the one to get. There is even a notch cut in the back for the cable. Nice touch.
It mounted up just fine and works great. However, did not come in the color I ordered. This wouldn't be a problem but my truck is black so I ordered a black mount to match. The 3d print quality is good in most parts but there are some areas where it looks like it was separating a little.
Hi Loren! Thanks for bringing this to our attention. We definitely want to make this right—we'll reach out via email and make sure to replace your mount with the correct color.
Super easy install looks great I honestly couldnt be happier strong construction feels rugged for the oil patch roads.
